Top painting companies in Jacksonville and house painting recommendations: Paint color may vary slightly from one can to the next. If you have to open a new can in the middle of a wall, the difference may be noticeable. Mixing the paints together eliminates the problem. It’s best to estimate the amount of paint you’ll need and mix it in a 5-gallon bucket (a process called “boxing”).
Determine how much paint you’ll need: Whether you’re painting a powder room or the exterior of your house, the general rule of thumb is one gallon per 400 square feet, says Carl Minchew, vice president of color innovation and design at Benjamin Moore. But that’s just a rough guideline: To get a more precise number, which you’ll definitely want for large projects, use a paint calculator like the ones provided by Benjamin Moore or Pratt & Lambert; they take into account window and door measurements. (And both assume two coats of paint per project.)
Sanding not only feathers out chipped paint but also provides “tooth” for the next coat of paint. For glossy trim, use a sanding sponge rather than sandpaper. Sponges mold to the shape of the trim and last longer than paper. When applying latex over alkyd paint or when he is not sure of the original finish, Brian Doherty, a painter in Richmond, Virginia, follows the hand-sanding with liquid sandpaper to make sure the surface is completely deglossed to prevent incompatibility problems. “I’ve seen homes where latex was used on oil-painted trim, and the paint started to peel in less than a year,” says Doherty. Unless you like textured walls, don’t paint over dust. Wash the walls with trisodium phosphate (TSP) or a mild cleaner, like Jasco’s TSP No-Rinse Substitute. For smoke-stained walls, Toto uses a 50/50 solution of bleach and water. To clean a wall, use two buckets. Load up your rag or sponge from your cleaning-solution bucket, and scrub. Before redipping, rinse the sponge in a second bucket filled with clean water. Read more info on Best painters in Jacksonville.
Nothing is more discouraging when you’ve finished painting than to peel tape off the woodwork and discover the paint bled through. To avoid the pain-in-the-neck chore of scraping off the paint, do a thorough job of adhering the tape before you start. “Apply tape over the wood, then run a putty knife over the top to press down the tape for a good seal,” a painter with more than 16 years of experience says. “That’ll stop any paint bleeds.” Use the blue painter’s tape instead of masking tape. Masking tape can leave behind a sticky residue that’s hard to clean off. Plus, paint can cause the tape to buckle or get wavy, which lets paint run underneath it. Painter’s tape can be left on for days (some up to two weeks) and still peel off cleanly. And it stops paint bleed without buckling.
Below you will find the absolute best painters in Jacksonville, FL. These award winning painters & painting companies have set themselves apart in the home painting and even the commercial painting industry. Home painting you can count on! See extra info on https://www.painters-jacksonville.com/.
